h a l f b a k e r yChewable.
add, search, annotate, link, view, overview, recent, by name, best, random
news, help, about, links, report a problem
browse anonymously,
or get an account
and write.
register,
|
|
|
When I want to turn the 3-speed ceiling fan off, I have to pull the chain some number of times - but how many? Is it on medium and needs two pulls, or on low and just needs one?
With the appropriately spaced markings on the base under the blades matching the frequency of the spin, or a Moire pattern
or something, it should be possible to make different speeds show different colors. Then I don't have to stand and wait to see if it's stopping, or just slowing down to low.
[link]
|
| |
Why not use a strobe light ? |
|
| |
Many ceiling fans have a light fitting below the motor annulus. It would be simple to put a strobe light on the upper side of the light fitting, so that it plays onto the blades; this would have the effect of making the blades appear to be stationary whatver their speed, as the flashes are triggered by a sensor on the motor analagous to a magneto on an engine (a magneto could actually be used). |
|
| |
Thus, when the fan is operating, the blades "aren't" moving; when the power is off, the strobe stops, thus when the blades apparently start to move, you know it's off. |
|
| |
Why no simply reach up with your pre-calibrated carrot on a stick and look at the blade impact readings? [+] |
|
| |
If you can't tell whether the fan is on medium or low speed,
then what is the point of its having medium and low speeds? |
|
| |
Keep pulling the chain until the blades pick up speed again. Then you know it's on high, and requires three more pulls. |
|
| |
your pre-calibrated carrot on a stick [marked-for-tagline] |
|
| |
//[MB] If you can't tell whether the fan is on medium or low speed, then what is the point of its having medium and low speeds// - If a ceiling fan falls in the woods does it make a noise? |
|
| |
I like the strobe idea, but it needs development. |
|
| |
If one of the blades (assuming a 3 blade fan) has a mark on it then the strobe can be set to flash at the same rate as the fan on high speed. This would make all the blades appear stationary and the mark would only apear on one blade. |
|
| |
At medium speed the blades would be moving slower but the strobe would be going at the same rate. This would still make the blades appear stationary (if medium is 2/3 of the rate of full speed) but the mark would appear on 2 blades at a time, alternating round. |
|
| |
At low speed (1/3 full speed) the strobe would make the mark appear on one blade at a time alternating round. |
|
| |
It may be difficult to tell the difference between medium and low to start with but since they arent going too fast it should be fine. |
|
| |
just have 3 different colored LEDs indicate different speeds. Obviously, if none of the LEDs are on, the fan is switched off.g |
|
| |
Make it a two-stage pull switch. Short pull = index power setting. Long pull = turn off/on. |
|
| |
This is easily done with a mechanical switch arrangement, but could definitely be improved with carrot-onna-stick callibration. |
|
| |
Over-engineering is such fun isn't it. |
|
| |
2 thoughts: Create a fan with 3 little lights on the base around the pull cord. 3 lights on - top speed. 2 lights - medium. 1 light - low. All off is, well, off. No brainer. Thought #2. Change out the on/off wall switch for a Dimmer Switch. Adjust the speed as incrementally as you like. |
|
| |